Smart Hardwire Kit doesn't seem to recognize ACC fuse tap/process

I've hardwired my RexingV1P in my front fuse panel via the Rexing Smart Hardwire Kit per the diagram on your page/included with kit with the primary power yellow wire running to an "always on" fuse (20A) and then the accessory red wire to a fuse that is ACC (forget if its a 5 or 15A) for only on when the car is on.

I have disabled parking mode yet the camera continues to stay on even after having switched off the ignition.   

If the ACC is hardwired, and the Parking Mode is disabled then the camera should shutoff after you turn off your ignition and/or 10-15 minutes for some "modern" cars who run some processes just after ignition switches off correct?   Mine continues to stay powered and recording constantly.

While I do want to use parking mode on occasion, like when away from home or parked somewhere other than my garage, I do not want to continue to have the dashcam record when Parking Mode is disabled and the vehicle sits in my garage overnight(s).

Does anyone have any troubleshooting tips for me to try to resolve this?